BeadSmith® 6-in-1 Looping/Bail Making Pliers

6-in-1 Looping Pliers. Make 6 loop sizes: 2mm-9mm. Used for bending and shaping wire. Double-leaf springs reduce hand fatigue with lap joint construction. Instructions for Making Connectors into Bails:
Step 1: Hold your connector. Firmly grip the center of the connector with your bail making pliers. The back side should face the smaller barrel.
Step 2: Curve your connector. First, bend one end of the connector along the curve of the smaller barrel, then repeat on the opposite end.
Step 3: Finish the bail.
a) Use the bail making pliers to round out any awkward bends by gently crimping down while following the curve of the bail.
b) Use chain nose pliers to align the holes on each end of the bail.
c) Loop a jump ring through both holes, then attach a pendant and close the jump ring.